Canadian Salon Company

Electric Installation – operating the Electric in to the Cabinet Print

This guide that is instructional assist in the planning/installation associated with the Electrical Power Supply for the Acrylic Spas.

Most of our acrylic tubs have actually detachable case panels which cover the perimeter that is entire of bath tub.

Whenever operating the electrical through the spa, the access point to the case doesn’t have become put appropriate at the Control Pack location. Our spas usually do not come loaded with a pre-drilled opening for electric so access may be through some of the case panels.*

*NOTE: We try not to advise setting up the electric through a case panel that is situated in front side a Pump, Control Pack, Blower, or Gate Valve. These panels will need to be likely eliminated sooner or later for maintenance or servicing.

Selecting a spot

Whenever choosing where you should enter the case, achieve this in line with the following:

• security (do not create tripping dangers)
• looks
• access points for users to go into the tub
• action positioning
• cover opening position (bottom mount lifters need the cover remainder low near the case)
• address lifter mounts

Producing an Access Point

A Spade Bit is not recommended since there are no pre-drilled holes, access through the https://hookupwebsites.org/japanese-dating/ panel is done using a Hole Saw for a clean cut. The perfect location to put a opening when it comes to cord, could be three to five inches up through the base regarding the case panel, and 4 to 6 ins in through the outside side of the case panel. Please be aware that the case panels have actually timber framework and insulating foam inserts. Attempt to avoid drilling through the timber frame since this will weaken the support that is structural timber provides.

We don’t recommend approaching through the bottom regarding the spa. Should this be the absolute most perfect route then we suggest you are taking under consideration that you’ll never be in a position to slip the bathtub at all.

This could pose issue if something specialist is needed to access a region of the bath tub this is certainly against an obstruction such as for instance a wall surface or deck.

The Control Pack (where in fact the electrical may be linked) will likely to be positioned behind one of several case panels straight below your Topside Control Panel (precise location shall differ according to spa model).

There was space that is enough the case to operate the ability cable through the access point out the Control Pack once we try not to totally fill the cavity with spray foam. The energy cable will need to go into the Control Pack through the hand side that is left.

To find out more about linking the electric to your circuit breaker, please click on our solution “Electrical Installation – Correct Wiring for a 240V Supply“.

In the event that you need any further help, please contact client Service.